Publicité
Les langues disponibles
Les langues disponibles
OPERATION
1. Squeeze the trigger and move the surface cleaner
back and forth and/or side to side to begin cleaning
(See Figure 2).
2. Never operate in the same area for more than 2
seconds, damage may occur.
NOTE: If striping or swirling occurs:
1. Slow your pace and try cleaning the area by going
back and forth and side to side.
2. Try overlapping when cleaning by 50%.
3. Check to see if one or both of your nozzles are
clogged. Follow the maintenance instructions below.
NOTE: Always squeeze the gun's trigger to release any
residual pressure immediately after use. Engage the
trigger lock when not in use.
CAUTION:
Striking any raised obstacle while using the surface cleaner could damage the unit. If contact does
occur and causes vibration when operating the surface cleaner, stop use immediately. Continuing
to operate the unit could result in serious injury.
MAINTENANCE
A clogged or dirty nozzle will result in excessive pump
pressure causing a pulsing sensation and/or excessive
vibration.
1. Turn off the pressure washer and turn off the water
supply. Release the residual pressure by squeezing
the gun's trigger.
2. Disconnect the pressure washer wand from the
surface cleaner.
3. Using a 14mm wrench (not provided) remove both
nozzles from the spray bar. (See Figure 3)
4. Using the nozzle cleaning tool, free any foreign
material clogging or restricting nozzle openings.
(See Figure 4)
5. Flush debris out of the nozzle. Direct the flow of water
through the nozzle backwards from the outside to the
inside.
6. Attach the wand back to the surface cleaner, set the
surface cleaner on a flat surface. Turn on the water
(DO NOT START THE PRESSURE WASHER) and
squeeze the trigger on the gun. Allow water to run
through the spray bar for approximately 30 seconds.
Figure 2
Spray Bar
Figure 3
Figure 4
4
Nozzle
Nozzle
Cleaning
Tool
Nozzle
Opening
www.surfacemaxx.com
Publicité
