Publicité
Les langues disponibles
Les langues disponibles
DS 58190 B IN
requirements in an accessible location. If the hood includes a direct mains connection, use a double pole
switch with a minimum distance between open contacts of 3 mm (accessible).
4 Study Figure A.
5 For wall installation drill three 8 mm holes every 100 mm in line with the hook of the hood.
6 Insert the rawlplugs.
7 Fix the hook to the wall and install the plate.
8 Fix the one-way valve with the screws supplied, add the reductor and the soot tube, and draw it outwards
(see Figure B).
9 Place on the wall (Figure C).
10 Calculate the final height of the U-shaped section and pull the inside of the U-shaped section up to the
correct height.
11 Secure the template in the lower tube using the screws supplied to mark out and drill two 8 mm holes in
the wall (Figure D).
12 Finally, drill two 8 mm holes in a suitable p lace in line with the second plate (Figure E) and tighten the
two screws.
English
Hook
Soot tube
Valve
U-shaped section
Plate
Drilling template
THE CLASS 1 HOOD MUST BE EARTHED
The connection should be made as follows;
BROWN
BLUE
YELLOW/GREEN
THE CLASS 2 HOOD MUST NOT BE EARTHED
Second class hoods with the characteristics label containing the double square symbol.
The connection should be made as follows;
BROWN
BLUE
NOTICE OF INSTALLATION
1. Before installation, please ensure the area is clean to avoid suction of the remaining bits of broken wood
and dust.
2. It cannot share the same air ventilation tube with other appliance such as gas tube, warmer tube, and
hot wind tube.
3. The bending of ventilation tube should be≥120°, parallel or above the start point and should be
connected to the external wall.
Spanish
Gancho
Conducto para el hollín
Válvula
Sección en forma de U
Placa
Plantilla para taladrar
=
L (live)
=
N (neutral)
=
Earth
=
L (live)
=
N (neutral)
14
Publicité
