LED2WORK TUBELED 40 II Integrated Manuel D'utilisation page 12

Mode 3: Incompatible with option cascadable
PIN 1 = 24V DC
PIN 2 = not used
PIN 3 = GND
PIN 4 = 24V DC
PIN 5 = not used
The voltage inputs at PIN 1 and PIN 4 are connected exclusive - OR. This makes it possible to switch the light ON or OFF
without additional switching devices (e.g. an external control cabinet).
As long as there is an exclusive supply voltage to the light, the light is switched on.
If there is no voltage (PIN 1 = 0 and PIN 4 = 0) OR if both voltages are present (PIN 1 = 1 and PIN 4 = 1) the light is swit-
ched off. If a second voltage is added to an already active voltage in order to switch off the light, only a small switching
current is necessary.
6 | Maintenance and Care
The LED light is maintenance-free. Do not make any alterations to the light.
The LED light sources mounted in the light are connected to the luminaire housing in a special way (thermal coupling)
and may react sensitively to electrostatic discharges (ESD). Improper replacement of the illuminant or other compo-
nents may impair the tightness of the light. That is the reason why repairs may only be carried out by the manufactu-
rer or by persons authorised and qualified by the manufacturer.
Turn off the light before cleaning and let it cool down completely. Clean the outside of the light with a soft, dry and clean
cloth. To remove excess dirt, moisten the cloth with water. Never use aggressive cleaning agents, as these may cause
discolouration of the housing.
12 | BA TUBELED_40 II Integrated . BA 01/2024
The light is not equipped with a ON/OFF switch. Usually you switch the light ON or OFF
via external switches of machines or systems.
Do not open the light!
No liability is assumed for damages resulting from the use of unsuitable cleaning agents.
PIN 1 PIN 1
PIN 4 PIN 4
Light
Voltage at PIN
Voltage at PIN
Action light