Kenwood KTC-V300N Mode D'emploi page 8

Specifications
Specifications subject to change without
notice.
TV Tuner section
Colour system
: NTSC
Channel selection system
: PLL frequency synthesiser system
Television system
: M
Channel converge
VHF : 2 - 13 ch
UHF : 14 - 69 ch
Demodulation system
: Split carrier system
Antenna input
: 4-ch diversity (3.5 ø miniplug)
General
Operating voltage
: 14.4 V DC (11 V - 16 V)
Current consumption
: 305 mA
Dimensions (W×H×D)
: 188 × 30 × 144 mm
7-3/8 × 1-3/16 × 5-11/16 inch
Operational temperature range
: -10 °C - +60 °C
Storage temperature range
: -30 °C - +85 °C
Weight
: 680 g
1.5 lbs
TV Antenna
Output impedance
: 75 Ω / 3.5 ø minijack
Operating voltage
: 8 V DC
Current consumption
: 85 mA
Cable length
: 4.0 m, 5.5 m
Film antenna element size (W×H)
: 345 × 94 mm
13-9/16 × 3-11/16 inch
Weight
: 375 g
0.8 lbs
8
|
English
FCC WARNING
This equipment may generate or use radio frequency energy.
Changes or modifications to this equipment may cause
harmful interference unless the modifications are expressly
approved in the instruction manual. The user could lose
the authority to operate this equipment if an unauthorized
change or modification is made.
NOTE
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment may cause harmful
interference to radio communications, if it is not installed and
used in accordance with the instructions. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.