System Connection; Control Unit - Kenwood KTC-V300N Mode D'emploi

Installing the Antenna

■ System connection

• To prevent short circuits, remove the key from the ignition and disconnect the - terminal of the battery.
• Make sure to ground the unit to a negative 12V DC power supply.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working
properly.
• Thoroughly wipe away oil and other dirt from the installation surface. Please avoid installation on uneven
surfaces.
To film antenna
Both the left and right cable connectors are
adhesive-backed.
TV tuner (KTC-V300N)
• Insert the connector with the
hook aligned until it clicks.
• Release the hook when
disconnecting the connector.
Hook
4
|
English
To film antenna
TV antenna cable
(Accessory 3 and 4)

Control unit

Monitor cable
(Accessory 6)