Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY INSTRUCTIONS
9. Assemble drum assembly (M) to motor (N) using
motor shaft pin (GG) and cotter pin (JJ). BE SURE
TO SECURE COTTER PIN PROPERLY BEFORE
MIXING ASSEMBLY IS IN MOTION.
HARDWARE USED
Cotter Pin
JJ
GG
Motor Shaft Pin
NOTE: The motor shaft may need to be rotated by
hand in order to install the cotter pin.
OPERATING INSTRUCTIONS
Ensure to attach the carabiner to the single chain link
prior to mixing or transporting the mixer.
Remove the carabiner from the single chain link
when you are ready to dump the drum.
Position 1
1. Before Using The Mixer
Ensure all bolts are tightened.
Position the mixer on a level surface.
NOTE: Maximum slope is 5 degrees.
Before filling the drum, make sure
the mixer can easily empty into a
wheelbarrow.
A "GROUND FAULT INTERRUPTER"
protected circuit is recommended for all
outdoor electric devices!
2. Transporting The Mixer
Always disconnect the power
prior to transporting the mixer.
Mixer can be transported in two ways.
Method 1:
a) Turn power to off ("O") position, disconnect
power cord.
b) Ensure drum is empty.
c) Facing front of mixer, grab handle and top
of drum. While holding right wheel down
with with your foot, pull mixer toward yourself.
Be careful not to tip mixer on yourself.
d) Move mixer to desired location.
1
1
Position 2
9
GG
N
S1
O/I
13
Black
L
23
White
N
Green
PE
L1 Phase Wire
N
Neutral Wire
PE Earth Wire
S1 Electromagnetic Switch
C1 Capacitor
METHOD 1
9
GG
JJ
M
14
Brown
Red
C1
Red
24
Black
A1
White
115Vac,60Hz,4.3A
T1 Thermal Motor Protector
M1 Motor
AA Motor Run Winding
AM Motor Start-up Winding
Position 1
Position 2
M1
AM
AA
T1
Publicité
