Publicité
Liens rapides
IMPORTANT MANUAL
OPERATOR'S MANUAL
MODEL:
PB24H54YT
LAWN TRACTOR
ALWAYS WEAR EYE PROTECTION DURING OPERATION
Visit our website: www.poulan-pro.com
Do Not Throw Away
03076
WARNING:
Read this Man u al and follow all Warnings and
Safety Instructions. Fail ure to do so can re sult
in serious in ju ry.
411261 12.27.06 AP
Printed in U.S.A.
Publicité
Manuels Connexes pour Poulan Pro PB24H54YT
Sommaire des Matières pour Poulan Pro PB24H54YT
- Page 1 MODEL: Read this Man u al and follow all Warnings and Safety Instructions. Fail ure to do so can re sult in serious in ju ry. PB24H54YT LAWN TRACTOR ALWAYS WEAR EYE PROTECTION DURING OPERATION Visit our website: www.poulan-pro.com 411261 12.27.06 AP...
- Page 2 SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROW ING OBJECTS. FAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. • Do not operate machine without the entire grass catcher, WARNING: In order to prevent ac- discharge guard, or other safety devices in place and ci den tal starting when setting up,...
- Page 3 SAFETY RULES Safe Operation Practices for Ride-On Mowers III. CHILDREN GENERAL SERVICE • Never operate machine in a closed area. Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to •...
- Page 4 PRODUCT SPECIFICATIONS CUSTOMER RESPONSIBILITIES • Read and observe the safety rules. Gasoline Capacity 3 Gallons and type: Unleaded Regular • Follow a regular schedule in maintaining, caring for and using your tractor. Oil Type (API-SG-SL): SAE 30 (above 32°F) SAE 5W-30 (below 32°F) •...
- Page 5 UNASSEMBLED PARTS Mower Mower Front Wheel (5) Large Retainer Springs - 7/16 (1) 3/4 O.D. Washers (1) Wheel (1) 1-1/4 O.D. Washer (2) Smaller Retainer Springs - 5/16 (1) Locknut (5) 1-3/16 O.D. Washers (1) Shoulder Bolt 3/8-16 (1) Anti-Sway Bar Slope Sheet (1) Oil Drain Tube For Future Use...
- Page 6 ASSEMBLY FIG. 3 INSTALL MOWER AND DRIVE BELT FIG. 2 (See Figs. 4-12) NOTE: You may now roll or drive your tractor off the skid. See MOWER AND DRIVE BELT ASSEMBLY Supplement Follow the ap pro pri ate instruction below to remove the Sheet for additional guidance on this assembly.
- Page 7 ASSEMBLY NOTE: Be sure mower side suspension arms (A) are point- • ATTACH MOWER SIDE SUSPENSION ARMS (A) TO ing forward before sliding mower under tractor. CHASSIS - Position hole in arm over pin (B) on outside of tractor chassis and secure with washer and retainer •...
- Page 8 ASSEMBLY • Turn steering wheel to position wheels straight for- CHECK FOR PROPER POSITION OF ALL ward. BELTS • ATTACH FRONT LINK (E) - Work from left side of See the figures that are shown for replacing motion and tractor. Insert rod end of link assembly through front mower blade drive belts in the Service and Adjustments hole in tractor front suspension bracket (F) and secure sec tion of this manual.
- Page 9 OPERATION These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their mean- ing. FAST REVERSE HIGH SLOW NEUTRAL CHOKE IGNITION SWITCH ENGINE START MOWER HEIGHT REVERSE ENGINE ON PARKING BRAKE MOWER LIFT ENGINE OFF OPERATION SYSTEM (ROS)
- Page 10 OPERATION KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. FIG.
- Page 11 OPERATION The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye dam age. Always wear safety glass es or eye shields while operating your tractor or per form ing any ad just ments or repairs. We rec om mend standard safety glasses or a wide vision safety mask worn over spectacles.
- Page 12 OPERATION • For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to de sired height. TO ADJUST GAUGE WHEELS (See Fig. 19) Gauge wheels are prop er ly ad just ed when they are slight ly off the ground when mower is at the desired cutting height in operating position.
- Page 13 OPERATION • To restart movement, slowly release parking brake and brake pedal. • Slowly depress appropriate drive pedal to slowest set- ting. • Make all turns slowly. TO TRANSPORT (See Figs. 13 and 21) When pushing or towing your tractor, be sure to disengage transmission by placing freewheel control in free wheel ing po si tion.
- Page 14 OPERATION • Insert key into ignition and turn key clockwise to “START” BEFORE STARTING THE ENGINE position and release key as soon as engine starts. Do not run starter continuously for more than fifteen sec onds CHECK ENGINE OIL LEVEL per minute.
- Page 15 OPERATION • Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual). • Sitting in the tractor seat, start engine. After the en- gine is running, move throttle control to slow position. Dis en gage parking brake •...
- Page 16 MAINTENANCE BEFORE EVERY EVERY EVERY EVERY EVERY BEFORE MAINTENANCE EACH SEASON STORAGE SCHEDULE HOURS HOURS HOURS HOURS Check Brake Operation Check Tire Pressure Check Operator Presence & ROS Systems Check for Loose Fasteners Check/Replace Mower Blades Lubrication Chart Check Battery Level Clean Battery and Terminals Check Transaxle Cooling Check Mower Levelness...
- Page 17 MAINTENANCE TRACTOR BLADE CARE For best results mower blades must be sharp. Re place Always observe safety rules when per form ing any main- worn, bent or damaged blades. te nance. BRAKE OPERATION CAUTION: Use only a replacement blade approved by the manufacturer of If tractor requires more than five (5) feet to stop at highest your tractor.
- Page 18 MAINTENANCE TO CHANGE ENGINE OIL (See Figs. 24 and 25) • Rinse the battery with plain water and dry. • Clean terminals and battery cable ends with wire brush Determine temperature range expected before oil change. until bright. All oil must meet API service classification SG-SL. •...
- Page 19 MAINTENANCE ENGINE OIL FILTER CLAMP Replace the engine oil filter every season or every other CLAMP oil change if the tractor is used more than 100 hours in one year. MUFFLER FUEL FILTER Inspect and replace corroded muffler and spark arrester FIG.
- Page 20 SERVICE AND ADJUSTMENTS WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST - MENTS: • Depress brake pedal fully and set parking brake. • Place attachment clutch in “DISENGAGED” position. • Turn ignition key to “STOP” and remove key. •...
- Page 21 SERVICE AND ADJUSTMENTS • Go to side of mower you wish to adjust. FRONT-TO-BACK ADJUSTMENT (See Figs. 30 and 31) • With a 3/4" or adjustable wrench, turn lift link adjust- IMPORTANT: Deck must be level side-to-side. ment nut (A) to the left to lower the mower, or, to the To obtain the best cutting re sults, the mower blades should right to raise the mower.
- Page 22 SERVICE AND ADJUSTMENTS TO REPLACE MOWER BLADE DRIVE BELT TO CHECK BRAKE If tractor requires more than five (5) feet to stop at highest MOWER DRIVE BELT REMOVAL (See Fig. 32) speed in high est gear on a level, dry concrete or paved •...
- Page 23 SERVICE AND ADJUSTMENTS WASH ERS RE TAIN ING RING AXLE COVER SQUARE KEY (REAR WHEEL ONLY) FIG. 34 TO START ENGINE WITH A WEAK BATTERY (See Fig. 35) WARNING: Lead-acid batteries gen- er ate ex plo sive gases. Keep sparks, flame and smoking ma te ri als away from bat ter ies.
- Page 24 SERVICE AND ADJUSTMENTS REPLACING BATTERY (See Fig. 36) TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 37) WARNING: Do not short battery ter mi nals by allowing a wrench or any other object to contact both terminals at • Raise hood. the same time.
- Page 25 STORAGE Immediately prepare your tractor for storage at the end ENGINE of the season or if the tractor will not be used for 30 days or more. FUEL SYSTEM IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS WARNING: Never store the trac tor with FROM FORMING IN ES SEN TIAL FUEL SYSTEM PARTS SUCH gas o line in the tank inside a building AS CARBURETOR, FUEL FIL TER, FUEL HOSE, OR TANK...
- Page 26 TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly. 2. See “TO START ENGINE” in Operation section. 3. Engine flooded. 3. Wait several minutes before attempting to start. 4.
- Page 27 TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Engine dies when 1. Reverse operation system 1. Turn ignition key to tractor is shifted (ROS) is not "ON" while ROS "ON" position. into reverse mower or other attachment See Operation section. is engaged. Engine continues to 1.
- Page 28 In the event you have a claim under this Warranty, you must return the product to an authorized service dealer. Should you have any unanswered questions concerning this Warranty, please contact: In Canada contact: Poulan Pro Poulan Pro Outdoor Products Customer Service Dept.
- Page 30 SERVICE NOTES...
- Page 31 SERVICE NOTES...
- Page 32 PARTS AND SERVICE This product has been expertly en gi neered and carefully manu fac tured to rigid quality stan dards. As with all mechanical products, some adjustments or part replacement may be necessary during the life of your unit. For Parts and service, contact our authorized distributor: call 1-800-849-1297 •...