Publicité
Les langues disponibles
Les langues disponibles
To remove the ash-pan from its position, pull the
handle firmly (Fig. 5). Once you have emptied
the ash, replace the ash-pan and push it into his
place again.
4.
LIGHTING AND USE
Important at first start: may come off a few drops
of condensed water from the stove, produced by
the humidity of the environment where the stove
was stored.
FIG. 4
FIG.5
It is very important that the first time the heater
is lit, it is done so slowly.
This is for the following reasons:
Stabilise cast iron parts.
Harden the joint sealant putty.
Advise:
We recommend that the first loads of fuel
be small.
To generate draw, heat the chimney by in-
troducing some burning paper in the gap
between the front and the deflector, di-
recting it toward the chimney.
While lighting for the first time, ensure the
room where the heater is located is well
ventilated as the paint work may let off
some fumes.
Keep the stove on for a few hours at this
intensity.
IMPORTANT! The total height of the fire
load should not exceed 50% of the height
of the combustion chamber.
The heater must be closed at all times dur-
ing combustion to prevent smoke from
leaking out. Only open to add fuel.
When the stove is running , opening opera-
tions must be performed slowly to avoid
smoke exit and an accidental burn.
The glasses are ceramics to radiate the
maximum heat. They can reach high tem-
peratures.
Daily use
After lighting up for the first time, your heater will
be ready for daily use.
Your heat requirements will be obtained based
on the frequency and the amount of firewood
you load.
When your heater is cold, we recommend lighting
it up slowly.
12
Publicité
