Nice HSMO Mode D'emploi page 5

graph 3.3). If the connection is made in advance, this may cause incorrect or
failed installation of the drivers.
Description of led indicators on the HSMO modem
LED
220 V
Battery
Data
Connection
TX Data
RX Data
3.2 - HSA1
To install HSA1, simply connect it to the control panel socket and USB port of the PC
as shown in fig. 3.
3.3 - "Teleservice" Software
Caution – To use the remote management function, the "Teleservice" software
must be installed on a PC connected to the modem. Installation of the software
implies acceptance of the clauses in the User License.
The "Teleservice" software can be used in combination with the HSMO modem or
directly in combination with the control panel via the specific adaptor cable HSA1. In
the latter case, at point 03 of the installation procedure, use the HSA1 cable to con-
nect the control panel to the PC.
To install the Teleservice software on the PC, proceed as follows:
01. Insert the software CD-ROM in the PC drive and wait for the main menu to be
displayed; if this is not started automatically, open "My Computer" and double
click on the CD-ROM icon and then on the file "Index.htm".
02. Select the required language, followed by "Installation" and follow the instruc-
tions on screen. At the end of installation, an application shortcut is created
directly on the desktop.
03. Only at this point, power up the HSMO and connect it to the USB port of the PC
using the relative cable.
If the drivers have not already been installed, also from other applications, the
STATUS DESCRIPTION
on Mains power ON
off Power failure
on Battery discharged
off Battery OK
on Data present in memory, downloaded from
systems
off No system data present in memory
on Telephone connection in progress
off No telephone connection in progress
flashing Data traffic present on USB
off Teleservice software not active or USB cable
not inserted
flashing Data traffic present on USB
off Teleservice software not active or USB cable
not inserted
English – 3