AGA MARVEL MA24BC Instructions D'installation, D'utilisation Et D'entretien page 18

Step 4: Assemble the panel to the door
The preferred method of attaching the panel to the door
is to clamp the panel to the door so it cannot move while
drilling the screw pilot holes. Use bar clamps or "C" clamps
with pads on the clamping surfaces that will not mar the
panel or the door. The custom overlay panel should be
flush with the top of the door and overhang the sides of the
door ⁄ " (5 mm) on each side. See Figure 13a. Drill holes
3
16
through the gasket extrusion using the 10 holes as pilot
holes. Use the drill size from the chart in Table "C", being
careful not to drill through the front surface of the panel, drill
no deeper than ⁄ " (12.7 mm) deep. If the overlay panel is
1
2
thinner than ⁄ " (16 mm) thick shorter screws will have to be
5
8
obtained. Fasten the panel to the door with the 10 screws
provided in the literature pack. (See Figure 23a). Remove
the clamps and replace the gasket in the gasket extrusion
channels of the door. Some force may be required to seat
the gasket into the channels. Be sure the gasket corners
are seated properly.
Material Type
Hardwood ⁄ " (3.2 mm) Diameter. Pilot Hole
1
8
Softwood ⁄
7
64
Table C
OVERLAY DOOR PANEL INSTALLATION
#10 Wood Screw
(2.8 mm) Diameter. Pilot Hole
MODEL DESCRIPTION
ML15RAP*RP Solid, Right Hand
ML15RAP*LP Solid, Left Hand
ML15BCF*RP Glass, Right Hand
ML15BCF*LP Glass, Left Hand
ML15BCP*RP Solid, Right Hand
ML15BCP*LP Solid, Left Hand
ML24RAP*RP Solid, Right Hand
ML24RAP*LP Solid, Left Hand
ML24BRF*RP Glass, Right Hand
ML24BRF*LP Glass, Left Hand
ML24BRP*RP Solid, Right Hand
ML24BRP*LP Solid, Left Hand
Glass, Right Hand
MA24BRF*RP
Glass, Left Hand
MA24BRF*LP
Solid, Right Hand
MA24RAP*RP
Solid, Left Hand
MA24RAP*LP
18
DOOR
DIM "A"
30 ⁄ " (77.1 cm)
11
32
with Lock
with Lock
27 ⁄ " (70.4 cm)
23
32
with Lock
with Lock
Table D