AGA MARVEL M60CSS Manuel D'instructions page 20

-Light power supplies mounted
Light
harnesses
from
cabinet-
INSTALLING THE ICE MAKER WATER VALVE
in power module
Figure 17
Solenoid
water valve
Gasket
Hose
Fitting
Copper Tubing
(provided by
customer) tubing
to run in front of
power module on
top of cabinet
NOTE
An inline water filter can be used with this ice maker and is
recommended. A shutoff valve should also be installed in
the water line. Do not use a self-piercing type valve.
Ice Maker (Solenoid) Connection
The water valve and the water line fittings are packed
inside the cabinet in a plastic bag.
Remove the two screws from the bracket which is on the
left side of the of the power module cover. Use these two
screws to install the water valve on the bracket as shown in
Figure 18.
Slip solenoid valve compression nut and compression
sleeve on copper tubing as shown in diagram. Tighten nut
onto water valve with adjustable wrench.
Remove the red plug from the end of the ice maker fill hose
coming from the cabinet and clamp the hose onto the water
solenoid valve as shown. Tighten clamp securely. Turn on
the water supply and check all fittings for leaks.
Bracket on left side
of module cover
Fill hose to
ice maker
Tube clamp (2)
Sleeve
Compression
nut
Figure 18
20
This clamp for tube positioning only.
Check to make sure tube is not col-
lapsed or restricted after connecting
opposite end to valve.