HomeMatic IP HmIPW-WGD-PL Notice D'installation Et D'emploi page 20

Restore factory settings
8 Restore factory settings
The device's factory settings can be restored. If you do this, you will
lose all your settings.
To restore the factory settings of the device, please proceed as follows:
• Press and hold down the system button (D) using a pointed ob-
ject (e.g. a pen), until the LED (D) starts to quickly flash orange for
4 seconds (see figure 10).
• Release the system button.
• Press and hold down the system button again for 4 seconds, until
the LED lights up green (see figure 11).
• Release the system button again to conclude the procedure.
The device will perform a restart. After the restart, you can again integrate
your device into your Homematic IP system.
9 Maintenance and cleaning
The product does not require any maintenance. Enlist the help of an
expert to carry out any repairs.
Clean the device using a soft, lint-free cloth that is clean and dry. Do not
use any detergents containing solvents, as they could corrode the plastic
housing and label.
38
10 Technical specifications
Device short description:
Supply voltage:
Current consumption:
Power consumption in
Standby:
Cable type and cross section:
Installation:
Protection rating:
Protection class:
Ambient temperature:
Dimensions (W x H x D):
Weight:
Subject to modifications.
Technical specifications
HmIPW-WGD-PL
24 V , +/-5 %, SELV
DC
110 mA max.
0.6 W
Rigid cable
0.12-0.50 mm²
only in normal commercial switch
boxes (device boxes) in accordance
with DIN 49073-1
IP20
III
-5 to +40 °C
96 x 96 x 40 mm
131 g
39