Publicité
Les langues disponibles
Les langues disponibles
Start-up
The shield (continuity wire) must be connected to "–" (=GND) at the
bus connection of the Wired access point (HmIPW-DRAP). The
shield must not be placed on the glass display.
5.2
Installation
The bus is powered by the Homematic IP Wired Access Point (HmI-
PW-DRAP). For further information, please refer to the operating
manual of the corresponding Wired Access Points.
To facilitate connection to the terminals, the green push-in terminal
can be removed from the device. To do this, release the mounting
plate, press the latch on the back next to the lock symbol and slide
the clamp out of the mounting plate to the side (see figure 2).
For the installation, please proceed as follows:
•
Disconnect the corresponding line of the incoming Homematic
IP Wired bus (see figure 3).
•
Connect the Homematic IP Wired bus to the bus connecting ter-
minals (see figure 4). To connect and loosen the individual wires,
press the orange clamp using a small screwdriver.
•
Place the mounting plate (A) in the flush-mounted box and fas-
ten it to the box using the screws supplied (see figure 5).
•
Place the display (B) in the mounting plate by fully engaging the
connecting pins in the mounting plate bracket provided for this
purpose (see figure 6).
•
Switch on the Homematic IP Wired bus again (see figure 7) to
activate the device's pairing mode (see „5.3 Anlernen" auf Seite
33).
32
5.3
Pairing
Please read this entire section before starting the pairing proce-
dure.
Please refer to the Homematic IP Wired System Manual for detailed
information on setup and control options.
To integrate the device into your system and enable it to communicate
with other devices, you must first add it. The following set-up and control
options are available:
Connecting to the Homematic IP Central Control Unit CCU3
For local, software-based configuration and control via PC, you have the
option to connect the device to a Central Control Unit CCU3 and to use
it in a wide range of programs (see „5.3.1 Anlernen an die Zentrale CCU3"
auf Seite 33).
Connecting to the Homematic IP cloud
For flexible use via the free smartphone app, you can connect the device
to the Homematic IP cloud (see „5.3.2 Anlernen an die Homematic IP
Cloud per Wired Access Point" auf Seite 35). You can
•
control the wired system via the smartphone app using the
Homematic IP Wired Access Point (HmIPW-DRAP) or
•
combine wired devices with wireless Homematic IP devices via
the Homematic IP access point (HmIP-HAP).
5.3.1
Connecting to Homematic IP Central Control Unit CCU3
To easily operate and configure Homematic IP Wired devices via software
as well as use them in central control unit programs, you have to connect
them to the WebUI. To connect the device to the Central Control Unit
CCU3, proceed as follows:
•
Set up your Central Control Unit CCU3 as described in the oper-
ating manual and connect the Homematic IP Wired Access Point.
•
Start the user interface "WebUI" on your computer.
Start-up
33
Publicité
