BREIL AW00 Mode D'emploi page 10

[Setting the Alarm Time]
Press button to set the alarm with the auxiliary time. (When pressing button
first time, pressing it continuously for at least 0.5 seconds will cause the auxiliary time to
advance in 1 minute increments. After that, the auxiliary time will advance by 1 minute
each time button
time to advance rapidly).
• The following occur when the alarm set time (auxiliary time) is reached:
When using the sound alarm: The alarm sounds for 15 seconds
When using the vibration alarm: the watch vibrates 10 times
After sounding or vibrating, the alarm is switched off automatically, and auxiliary time
switches over to primary time.
* Since the alarm set time is stored in the memory of the watch, when the alarm is
turned on again by pressing button
time stored in memory.
[Switching between sound alarm and vibration alarm]
The alarm notification method switches between the sound alarm and vibration alarm
each time button
• Blue identification mark: vibration alarm
• White identification mark: sound alarm
[Stopping the alarm from sounding or vibrating]
• When the time reaches the alarm set time, the alarm will either sound for 15 seconds
or vibrate 10 times.
6
is pressed. Pressing button
is pressed.
continuously causes the auxiliary
, the auxiliary time will switch over to the set
for the