Philips HU5930/10 Mode D'emploi page 17

Possible solution
Problem
NanoCloud technology evenly distributes invisible water
vapour into your room. In dry conditions moisture from the Air
It takes a long time
to reach the target Washer will be absorbed by walls, furniture, and other items in
humidity level.
your room. Ventilation of dry outside air will also increase the
time it takes to reach the target humidity.
When mist is very fine, it is invisible. The appliance has a
I do not see water
NanoCloud humidification technology, which produces healthy
vapor coming out
of the appliance. Is
humid air from the outlet area without formation of water mist.
it working?
Therefore, you cannot see the mist.
The first few times you use the appliance, it may produce
a plastic smell. This is normal. However, if the appliance
The appliance
produces a burnt smell, contact your Philips dealer or an
produces a strange
authorized Philips service centre. The appliance may also
smell.
produce an unpleasant smell when one of the filters is dirty. In
this case, clean or replace the filter concerned.
• You have not removed all packaging material of the filters.
The appliance is
extra loud.
• Change the fan speed to lower fan speed level.
The appliance still
Perhaps you did not touch and hold the reset button
indicates that I
correctly. Plug in the appliance, touch
need to replace a
appliance, and touch and hold the reset button
filter, but I already
3 seconds.
did.
Make sure that you have removed all packaging material.
to switch on the
for
EN 15