Publicité
Liens rapides
Publicité
Manuels Connexes pour PawHut D51-111
Sommaire des Matières pour PawHut D51-111
- Page 1 IN221100427V02_US_CA_UK_FR D51-111_D51-111V01 US_CA...
- Page 2 PART ① ② ③ ④ ⑤ ⑥ ⑦ ⑧ ⑨ ⑩...
- Page 3 EN_Tracks facing in FR_Pistes face à Insert a non-locking Wheel into the Right Side Panel so the holes line up, then insert Bolt. Align the hole in the bottom of the Back Panel with the hole in the Side Panel that you just placed the Bolt through. Using the Hex Wrench, screw in the Bolt through the Side Panel and into the Back Panel;...
- Page 4 EN_Attach the Roof Panel by sliding the right rear lower wire extension under the support tabs and into the hole on the Side Panel. Slide the rest of the lower wire extension under the open tabs and into the hole in the left Side Panel.
- Page 5 EN_Attach side panel with 4 more hex Bolts and tighten all. FR_Fixez panneau le latéral avec 4 boulons hexagonaux supplémentaires et serrez -les tous.
- Page 6 EN_The Roof Panel should swing freely and close by latching into the front open tabs on the front top frame bar. FR_Le panneau de toit doit pivoter librementet se fermer en s’accrochant aux les languettes ouverts avant sur la barre avant du cadre supérieur.
- Page 7 EN_Attach the plastic Ramp to the bottom side of the plastic Shelf by snapping into the plastic clips. Place the assembled Shelf and Ramp in the cage through the door. Attach the Shelf and Ramp assembly to the 7th wire up from the bottom on the left side of the cage. FR_Fixez la Rampe en Plastique au bas de l'étagère en plastique en l'enclenchant dans les clips en plastique.