NORAUTO NO6740 Mode D'emploi page 77

ADDITIONAL FUNCTION
Charge Phone QC3.0:
A USB port (2) compatible with
QC3.0 fast charge technology is
available on the side of the jump
starter. Connect the USB cable
to the USB output port of the
device, press and hold the power
switch (6) for 3 seconds to turn
on the unit; the device will start
to charge. The USB output will
be automatically turned off after
charging is completed.
Wall plug:
10% 25% 50% 75% 100%
To recharge the device, firstly,
connect the charging output port
of the provided charger(reference
WJG-Y131400900W) to the
product input port, and then
connect the charger plug to the
230V power supply. At this time,
the LED will display the charging
status. After fully charged, the
LED will stop flashing.
QC3.0
30%
75
12V output:
10A
WARNING: This port is not a
charging interface! It should not be
connected to any other devices than
the female cigarette lighter adapter
provided with this product.
1. Plug one end of the equipped
cigarette lighter adapter into the
product's 12V 10A output.
2. Connect the 12V device to the
other end of the cigarette lighter
adapter cable.
3. Press and hold the power switch
(6) for 3 seconds to turn on the
unit to start supplying 12V 10A
for the car.
LED Light:
OFF
Press and hold the power
switch (6) for 3 seconds to turn
on the unit.
- 1st short press: Working light
- 2nd short press: Flashlight,
- 3rd short press: Light Off.