NORAUTO NO6740 Mode D'emploi page 76

HOW TO JUMP START YOUR CAR
WE STRONGLY SUGGEST TO VERIFY THE VOLTAGE OF
THE CAR BATTERY IS 12V BEFORE STARTING. IF IT IS
BELOW 2V OR ABOVE 12.6V, IT CAN'T BE JUMP STARTED.
WARNING: When using this unit to start, make sure the positive
and negative connections are correct, otherwise the battery may
explode.
1
Press and hold the power switch
(6) for 3 seconds to turn on the
unit. Make sure the battery level
is over 50%.
3
GREEN
GREEN
After the connection is
completed, a green light (10) on
the SSC case (12) will indicate
the correct status to jump start.
Start the car and do not crank
over 5 seconds.
50%
3 seconds
3 Seconds
ON ON
OFF OFF START START
2
1 2
Follow the steps below for jump
start, otherwise it could be
dangerous:
1. Connect the black (-) clamp
to the metal part of the engine
(negative ground) or to the
negative battery terminal.
2. Insert the jump start plug (8)
into the jump start port (1) of
the device.
3. Connect the red (+) clamp
to the positive (+) battery
terminal.
4
(Standby)
3 2
After the engine is successfully
started, first pull out the jump
start plug (8) of the device and
then remove the clamps from the
car battery.
74
Red
Red
(Standby)
(Standby)
3
Red
1