Publicité
Les langues disponibles
Les langues disponibles
REVERSE THE DOOR
Reverse the door (Fig. 20).
The refrigerator door can be opened both from the left or right as
required. The following are the steps required to position the door to
open to the right (Fig. 20)
1.
Unscrew the upper vent frame.
2.
Unscrew the hinge bolt from the vent frame and screw it on the
opposite side of the vent frame.
3.
Remove the door from the bottom hinge.
4.
Unscrew the bottom hinge on the right side and remove the screw
hole plugs on the left side.
5.
Remove the bolt from the hinge. Turn the hinge 180° and screw in
the bolt on the opposite side.
6.
Screw the hinge on the left side of the appliance. Insert the hole
plugs on the right side.
7.
Fit the door on the bottom hinge.
8.
Install and screw the upper vent frame and the hinge bolt. The
hinge bolt must be in the upper hole of the door hinge.
9.
Screw the door handle on the correct side.
10. When installed, open and close the door to ensure it operates
smoothly.
INSTALLATION
VENTILATION
Level the kitchen cabinet unit with a spirit level and a try square. Level
the unit by placing packing material underneath if required. A mini-
mum gap of 38mm must be maintained at the back of the appliance
for ventilation. Air inlet A must be at least 200 cm square and air must
flow through the panel in the cabinet plinth. Check that the position of
the power socket (1) is correct. Mains voltage where the appliance is to
be used must comply with that shown on the data plate located on the
left inside wall of the appliance next to the vegetable bins. The power
supply must be suitably earthed.
INSTALLATION OF THE APPLIANCE
Installation of the appliance should be performed by a qualified install-
er. The appliance should be placed in furniture case. Run the mains
cable through the unit such that it can be connected to the power sup-
ply after installing the appliance. Remove the cover (6) only if space is
restricted. Place the refrigerator into the kitchen unit. Fix the brackets
(1) with screws (2) onto the upper frame when two third of the refrig-
erator has been inserted. Then insert the refrigerator in completely,
ensuring that the gib clamp of the brackets stuck on the horizontal
- 53 -
Publicité
