Publicité
Les langues disponibles
Les langues disponibles
3.(*) One Star storage is for the frozen food which keeps the inner temparature lower
than -6 °C.
(**) Two Star storage is for the frozen food which keeps the inner temparature lower
than - 12 °C.
(***) Tree Star storage is for the frozen food which keeps the inner temparature lower
than - 18 °C.
(****) FOUR Star storage is for the freezing the food from +18 TO – 18 °C. It also keeps
the foods under 3 star storage conditions.
4. Your fridge is designed to operate in the ambient temperature intervals stated in the
standards, according to the climate class stated in the information label. We do not
recommend operating your fridge out of stated temperatures value limits in terms of
cooling effectiveness.
Installation instructions
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
! Check the installation dimensions according to fig.C. The position of the joint between
the unit doors must be level with the position of the joint between the appliance doors.
1. See fig.A for the necessary attachment components.
2. Insert trim flap
3. Pass the power cord through ventilation shaft and position it so that the appliance could
be easily plugged in once it has been installed. (fig.B - fig.C)
4. Take out the trim gasket
reverse side of the door hinges of the appliance. (fig.D - fig.E)
5. Raise appliance and slide into the kitchen unit. Push the appliance to the reverse side
of door hinges providing that the trim gasket
kitchen unit.
6. Align front feet with the front surface of the kitchen unit. (fig.F)
7. Screw the front feet by using screws
8. Screw the trim flap
9. Screw the fixing bracket
the opposite side. (fig.H)
10. Screw guides
unit door as it is opened at right angle. Slide rails
Screw the rails
11. Set 1~2 mm gap on the handle side between the unit itself and the unit doors by adjusting
the guides
. This is vital for appliance performance. (fig.J)
3
into slot and screw by screws
1
located on the side panel of the appliance and stick it on the
2
to the kitchen unit using screws
1
, as leaned to kitchen unit by using screws
11
to the appliance doors with screws
3
to the unit doors with screws
4
. (fig.D)
6
covers space between appliance and the
2
. (fig.F)
5
. (fig.G)
5
. Lean the appliance doors to the
6
into the guides
4
. (fig.J)
5
EN - 36 -
. Repeat this for
5
aligning the groove.
3
Publicité
