PowerXL BL7019 Serie Guide D'utilisation Et D'entretien page 11

Troubleshooting
ERROR MESSAGES
"AL": The screen will display "AL" for "add liquid". This means the recipe is too thick
and there is an air bubble over the blades. To resolve, add liquid and/or stir and
mix. Continue by entering Smart Functions, or choose a manual speed.
"H": The screen will display "H" prior to an over heated situation. This is a precaution
to extend the life of your blender motor. To resolve, press power to power down
and allow 1 minute for your blender to cool down. Restart and the blender will
automatically know when it is ready to blend again.
"Er": The screen will display "Er" when the touch interface has been held more than
30 seconds. To resolve, clean the touch surface with a dry wipe, making sure no
liquid residue is left behind. Then press power and restart.
SMART SENSING FUNCTIONS NOT WORKING
The smart sensing functions of the unit work through sensing and advanced
intelligence. Sometimes with different incoming voltages or after repeated use of the
blender it may need a "Tune Up." Run the following calibration cycle to realign the
smart sensing functions:
1.
Place 1 cup of water into the large jar with the blade assembly attached.
2. Assemble to the appliance base and place the blender lid on top of the jar.
3.
Press Crush and Chop at the same time for 3-5 seconds. "C" will appear on the
display.
4.
Press play. The calibration will run automatically for 7-10 seconds.
5. When the unit finishes calibrating, it will return to the "On" mode. The calibration
is now complete and can be used as intended.
BL7019Series_BL_30374_ESF_IB_A.indd 11 BL7019Series_BL_30374_ESF_IB_A.indd 11
11
7/9/24 3:15 PM 7/9/24 3:15 PM