Kenwood KS-908HT Mode D'emploi page 6

Surround speakers
1. Attach the bracket using supplied screw as shown
below.
Be sure to attach in
the upper hole.
2 Screw a single screw into the wall at the desired
location. Screw it only part way in, so that the screw
projects 12 to 14 mm (1/2 to 9/16 inches) outward from
the wall surface.
3. Hang the speaker by fitting the top mount hole (at the
upper rear of the speaker) over the extending part of
the screw. Confirm that the speaker is held firmly and
securely in place.
12 - 14 mm
(1/2 - 9/16")
Precautions
Please observe the following precautions when mounting speakers onto the wall.
• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. 1.1 kg [2.4 lb]).
• Wall screws must be purchased separately. Be sure to use screws that are appropriate for the wall you are using, and that
are long enough to provide sufficient strength.
• If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of
installation, please consult a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury
or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient
support strength.
6
EN
Center speaker
1. Remove the base.
2. Attach the bracket, using screws which are removed
in step 1.
3. Screw two screws into the walls 120 mm (4-3/4 inches)
apart, making sure that screws are horizontally level.
Screw each screw only part way in, so that the screw
projects 12 to 14 mm (1/2 to 9/16 inches) outward from
the wall surface.
120 mm
(4-3/4")
4. Hang the speaker by fitting the two mount holes (at
the rear of the speaker) over the extending part of the
screw. Confirm that the speaker is held firmly and
securely in place.
12 - 14 mm
(1/2 - 9/16")