Publicité
Les langues disponibles
Les langues disponibles
Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock or personal
injury, mount to outlet box marked "Acceptable for fan support
of 35 lbs. (15.9 Kg) or less", and use screws provided with the
outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
mounting bracket (A).
□
Install the ceiling mounting bracket on the outlet box by sliding
the mounting bracket (A) over the two screws (II) provided with
the outlet box. If necessary, use leveling washers (not included)
between the mounting bracket (A) and the outlet box. Note that
the flat side of the mounting bracket (A) is toward the outlet box.
When using close-to-ceiling mounting, it is important that the
mounting bracket be level.
□
Securely tighten the two mounting screws (II).
II
3
Connecting the safety cable
□
Turn a wood screw (DD) into the ceiling.
□
Place the looped end of the safety cable (T) onto the wood
screw and then tighten the screw firmly, or connect the
safety cable directly to outer joist.
2
Hanging the fan
□
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Insert the ball portion of the ball/downrod assembly (D) into
the socket of the slide-on mounting bracket (A).
□
Turn the ball/downrod assembly (D) clockwise until it is
seated with the tab of the slide-on mounting bracket (A)
aligned with the slot in the ball.
A
D
B
C
E
II
F
A
DD
8
T
A
Publicité
