Avady POOLeasy Notice D'utilisation page 12

2.8. Alarms
Any alarm triggered: - will immediately be displayed on the screen.
Any alarm triggered: - will automatically and immediately stop production.
Any alarm triggered: - can be manually cleared by pressing and holding the bottom key.
Message Fault
displayed detected
Production
A1
anomaly
Short-
circuiting of
A2
the
equipment
ACTIVATING/DISABLING ALARM A1:
I
Alarm A1 is disabled by default.
1) Press and hold down the bottom key, until the message In is displayed.
2) Press the top key x times, until the message AL is displayed.
3) Press the bottom key (one of the following displays will flash.
4) Using the top key, move to position On to activate alarm A1
5) To confirm, press the bottom key: the display freezes for a moment.
Alarm A2 is always activated and cannot be disabled.
Cause
Check that the pipe at cell level is completely filled with water, and the
Low water
flow is sufficient.
- Check the salt levels in the pool using a recent testing kit.
Low salt - Top up with salt if necessary, so as to obtain a salt level of 5 kg/m
(or 2.5 kg/m 3 for Low Salt equipment).
- Check that the electrical connections to the terminals of the cell are
sufficiently tight and not oxidised.
Problem in - Check that the cell's power cable connector is correctly connected to
the cell the electronics unit.
- Check that the cell is not scaled.
- As a last resort, replace the cell.
Problem in
the
Contact a professional to repair the electronics unit
electronics
unit
- Check that the electrical connections to the terminals of the cell are
Problem in sufficiently tight and not oxidised.
the cell - Check that the cell's power cable is in a good condition.
- As a last resort, replace the cell.
Problem in
the
Contact a professional to repair the electronics unit
electronics
unit
or to oF to disable alarm A1.
Checks and solutions
3
5