Publicité
Les langues disponibles
Les langues disponibles
2. ELECTRONICS UNIT
2.1. Interface
1
2
ELEMENT
Red LED
Green LED
Screen
2.2. Switching on
When connecting the electronics unit to a power supply:
After about a minute, production starts automatically, according to the setpoint displayed on the screen.
If the electronics unit is powered off (screen off, red LED on):
Press twice on the upper control key. After about a minute, production starts automatically, according to the
setpoint displayed on the screen.
2.3. Switching off
Set the production setpoint to 00 using the top key (no confirmation required): after a few seconds, the screen turns
off and the red LED comes on.
The internal ventilator of the electronics unit may continue running as long as the unit is powered on.
2.4. Adjustment of the inversion frequency of the current supplying the cell
(optional)
I
Inverting the flow aims to prevent limescale deposits on the cell. The frequency at which flow is inverted
must be correctly set following the table below in order to ensure that the cell continues to operate correctly over
the long term.
Possible settings: 02, 04, 06, 08, 10, 12, 14, 16 (hours).
Default setting: 04.
Water hardness (°f)
Water hardness (mg/l)
Inversion frequency
(hours)
1) Press and hold down the bottom key, until the message In is displayed.
2) Press the bottom key: the current setting flashes.
3) Select an inversion frequency using the top key.
4) Confirm with the bottom key: the display freezes for a moment.
Non-contractual images
3
STATUS
Continuously on
Flashing
Continuously on
Default display
Flashing display
Steady display
0 to 2
2 to 5
0 to 20
20 to 50
16
14
1 : Red LED
2 : Green LED
4
3 : Screen
4 : Control keys
Electronics unit powered off
Information awaiting validation, or alarm
5 to 8
8 to 12
12 to 20
80 to
50 to 80
120 to 200 200 to 400 400 to 600
120
12
10
MEANING
Alarm activated
Production in progress
Production setpoint
Confirmed information
20 to 40
40 to 60
8
6
> 60
> 600
4
2
3
Publicité
