FAR DP2024W Manuel D'utilisation page 26

ENGLISH
INSTALLATION
Position the appliance and allow it to stand for
two to three hours before it is turned on for
the first time to allow the system to settle. Do
not position next to any heat source e.g. cooker,
boiler or in direct sunlight etc.
Allow at least 10 cm of space at the top and
10 cm of space on both sides of the appliance and
between the back of the appliance and the wall
for adequate air circulation.
designed for recessed installation ("building in").
Install on a good firm level surface, and any
unevenness of the floor should be corrected
prior to installation, slight unevenness can be
overcome by adjusting the front feet.
NOTE: If the appliance is positioned on a
carpet, soft floor covering you should readjust
the front feet once the appliance has had time to
settle.
USE
• is appliance is designed to operate in
ambient temperature between 16°C and 38°C.
If these temperatures are exceeded, i.e. colder
or warmer, the appliance will not operate
GB-8
e appliance is not
correctly. If the ambient temperatures are
exceeded for long periods, the temperature in
the freezer section will rise above -18°C and
food spoilage may occur.
• Remove all packaging materials from the
appliance. Wash the inside of the cabinet with
lukewarm water and bicarbonate of soda (5
ml to 0.5 liter of water). Dry the appliance
thoroughly.
• When you use the freezer for the first time
or after defrosting, set the thermostat control
to the maximum position for at least 2
hours before introducing food to be stored,
and then readjust to the normal position.
• If there is a power failure, do not open the
door. Frozen food should not be affected
if the failure lasts for less than 12 hours. If
the failure is longer, then the food should
be checked and either eaten immediately or
cooked and then re-frozen.
SETTING THE THERMOSTAT KNOB
e refrigerator is controlled with a thermostat
knob located inside the fridge, towards the
upper right-hand corner. Turn the knob from
ENGLISH
GB-9