Beko HIXI 64700 UF Manuel D'utilisation page 31

5. Turn the lock knob and lock it by insert-
ing the chamber back into its slot.
Cleaning the bottom cover
If the bottom cover on the bottom of the
product becomes dirty, you may be able to
remove it and clean it.
To remove the bottom cover:
9 Troubleshooting
If the problem persists after following the
instructions in this section, contact your
vendor or an Authorized Service. Never try
to repair your product yourself.
The product does not work.
• Fuse may be faulty or blown. >>> Check
the fuses in the fuse box. Change them if
necessary or reactivate them.
• The appliance may not be plugged to the
(grounded) outlet. >>> Check if the appli-
ance is plugged in to the outlet.
• (If there is timer on your appliance) Keys
on the control panel do not work. >>> If
your product has a key lock, the key lock
may be enabled, disable the key lock.
• If the hob does not turn on when the on/
off key is pushed >>> Unplug it and wait
at least 20 seconds before plugging it in.
• It has overheat protection. >>> Wait for
your hob to cool down.
• Appropriate pots may not be used. >>>
Check your pots.
1. Remove the top drawer located under
the hob. You should be able to reach un-
der the hob.
2. Reach the bottom cover from under the
hob.
3. There are 5 locks in the directions
shown by the arrow symbols on the bot-
tom cover. By releasing these locks, re-
move the bottom cover by holding it
downwards.
4. After cleaning the bottom cover, push it
upwards hard in the same direction so
that the locks fit into their slots.
icon is always lit on the hob
zone display.
• Pots may not be placed on the operating
hob. >>> Check if there is a pot on the
hob zone.
• Your pot may not be induction suitable.
>>> Check if your cooker is suitable for
the induction hob.
• The pot may not be centred correctly on
the hob zone or the bottom surface of
the pan may not be wide enough for the
selected hob zone. >>> Center the hob
zone by choosing a pot that is wide
enough for the hob zone.
• The pot or hob zone may be too hot. >>>
Wait for them to cool down.
The selected hob zone suddenly turns off
while it is operating.
• The cooking time of the selected com-
partment may have expired. >>> You can
set a new cooking time or finish cooking.
• It has overheat protection. >>> Wait for
your hob to cool down.
• An object may have covered the touch
control panel. >>> Remove the object on
the panel.
EN / 31
EN
IT
FR