• The selected level may be reduced. How-
ever, this is not reflected on the display.
Overflow protection system
Your cooker is equipped with an overflow
protection system. In case of any overflow
on the control panel for any reason, the sys-
tem cuts off the power connection auto-
matically to turn off your cooker. Mean-
while, "F" warning appears on the display.
6 Using the ventilation
General warnings
• There is a motor with various speeds for
ventilation. In order for the device to per-
form well, we recommend using low
speeds under normal conditions and high
speeds in case of strong odour and va-
pour condensation.
Ventilation modes
This device is used in 2 modes: Internal cir-
culation and external circulation mode.
Inner circulation
The air sucked from the middle of the
cooker is first purified from oil by passing it
through the oil filter. It is then passed
through an activated carbon filter and
transferred back into the kitchen.
CAUTION: In internal circulation mode, ac-
tivated carbon filters should be installed in
the area defined in the product to keep the
odour particles in the inhaled air. For differ-
ent types of installation versions defined
for internal circulation of the appliance,
refer to the installation manual or consult
your authorized dealer.
Outer circulation
Precise power setting
Induction cooker responds to the com-
mands issued immediately as per its oper-
ating principle. Its power settings are
changed very rapidly. Thus, you may pre-
vent overflowing of a meal (water, milk)
that is about to overflow by turning the ap-
pliance off immediately.
The air, which is sucked from the middle of
the cooker, passes through the oil filters
and is discharged to the outside through
the chimney with a pipe system.
Ventilation mode setting
The product is pre-set to inner circulation
mode.
In order for the product to be in external cir-
culation mode, the
made appropriate in the settings section.
Manual ventilation setting
ü Ventilation can be set manually.
1.
Turn the cooker on by touching the
key.
ð » The "0" symbol will be displayed
on the displays of the ventilation.
2. By tapping on the ventilation setting
area or by sliding your finger on the
area, set the speed level between "1"
and "3".
Turning off manual ventilation
1. By tapping on the ventilation setting
area or by sliding your finger on the
area, set the speed level as "0".
Turning on the intensive ventilation mode
1. Intensive ventilation mode can be activ-
ated by touching the
ð Intensive ventilation mode works
for a maximum of 8 minutes. Dur-
ing this time, the P icon flashes in
the display. After 8 minutes, the
ventilation speed drops to 3 and
continues to operate at this speed
level.
EN / 25
setting must be
key.
EN
IT
FR