OZ Lifting Products WHEEL BASE Manuel De L'opérateur page 31

Lubrication
General Lubrication Guide
Some components are minimum maintenance and do not require service. Follow the chart for the components that
require set service lubrication intervals.
Component(s) Maintenance Task
Sliding Parts Lubricate The Sliding Parts
Load Sheave
Apply Light Coat Of Grease
Bushing
Winch Shaft
Apply Light Coat Of Grease (Do Not
Bearing
Get Grease On The Brake Pads)
Front Wheel
Apply Grease Through Zerk Fitting
Axles
Cleaning
The Wheel Base by OZ Lifting Products, LLC
corrosion. The Wheel Base by OZ Lifting Products, LLC
lubricated.
NOTE: No solvents should be used on any parts of the Wheel Base by OZ Lifting Products, LLC
any other purpose.
CAUTION
Light Wash Down
Wipe the surfaces of the crane with a wet cloth. Detergents are not necessary. The steel surfaces should have a light film
of oil applied to them to prevent corrosion. Remove any excess oil with a clean cloth.
NOTE: No lubricants of any kind should be applied to the brakes in the winch. If the brake pads get contaminated
with oil, they may slip.
should be periodically cleaned to preserve its appearance and to prevent
®
will last longer and perform better when it is kept clean and
®
The frame and component finishes are not warranted if equipment is installed in
a wet environment or exposed to harsh cleaners or high-pressure wash downs.
Wheel Base Operator's Manual • OZ Lifting Products, LLC
MAINTENANCE
Lubrication Recommended
Type Lubricant
Grease Standard Grease
Grease Standard Grease
Grease Standard Grease
Grease Standard Grease
• 6/2024
®
Interval
160 Hours
320 Hours
320 Hours
320 Hours
for cleaning or
®
31