Publicité
8
OCV Series
11.
其他的重要信息
¼ '' TS
13.
14.
15.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
法律声明
12.
MUSIC Group
MIDAS, KLARK TEKNIK, LAB GRUPPEN,
LAKE, TANNOY, TURBOSOUND, TC ELECTRONIC,
TC HELICON, BEHRINGER, BUGERA
MUSIC Group IP Ltd.
© MUSIC Group IP Ltd. 2016
保修条款
music-group.com/warranty
16.
17.
2000
Introduction
Thank you for purchasing this TANNOY Product loudspeaker. This product range is suited for high-level music and speech reinforcement applications requiring
exceptional sonic quality with uncompromised reliability.
Unpacking
Every TANNOY product and accessory is carefully inspected before packing. After unpacking, please inspect your product to make sure no damage has occurred in
DDA
transit. In the unlikely event of any damage, would you please notify your dealer immediately and retain your shipping carton, as your dealer may ask you to return the
faulty unit to them for inspection.
Each OCV loudspeaker is provided with the following accessories as standard; cable clamps, 1 x hanging cable, 1 x safety cable, 1 x terminal weather boot,
1 x euroblock connector, 3⁄8" screwed rod adaptor, cable ties.
Safety Notices
Some regional construction codes require the use of a secondary method of securing loudspeakers in ceiling to provide security of a backup support. A secondary
support line should be attached from the safety loop on the rear of the product to a source point on the ceiling. Please consult the relevant construction codes in
your region. TANNOY will not be held responsible for any damages caused by the improper installation of these loudspeakers.
SAFETY NOTE:
In order to comply with the relevant fi re safety regulations (ie. BS 5839:1998), it is required that in the event of fi re, that failure of the circuit to which the loudspeaker is connected does not occur before evacuation of the building is complete. Suitable measures include:
- a) use of terminal blocks (for connection to primary) with a melting point of not less than 650°C, for example constructed from ceramic materials; b) use of terminal blocks of a lower melting point but protected with thermal insulation; c) use of terminal blocks such
that, on melting, an open-circuit or a short-circuit does not occur.
Quick Start Guide
9
Publicité
