Facom BSYS.TKVAN Notice Originale page 24

CONNECTING THE CROSSBARS
The rack has two crossbars. The bottom crossbar should be connected no less than 250 mm (9
upper crossbar no less than 250 mm (9
When possible, the optimal crossbar spacing is in a way the crossbars divide the height of the rack into three parts.
INSTRUCTIONS
Step 1 – Lower Crossbar
Parts (x1) D (crossbar)
(x4) L (75 mm screw)
(x4) J (nut)
(x4) M (small washer)
1. Place both rack supports on the
floor, with the open side of the
bottom profile facing down.
 Note: tThe rack bottom crossbar
should be connected no less than
250 mm (9 ") from the van floor
/
7
8
and with the Facom
®
same side as the closed side of the
bottom profile.
2. Connect the bottom crossbar to both
supports.
 Note: Connecting the
brackets on the top profiles, make sure to place the spacers according to the location you plan on connecting the
mounting brackets.
INSTRUCTIONS
Step 2 – Spacer Sleeves
Parts (x6) E (spacer)
[x8 for Kit2]
3. Slide three spacers onto each of
the supporting top profiles before
connecting the upper crossbar.
 Note: The open side of the spacers
should be facing the closed side of
the top profile.
8
") from the bottom one.
/
7
8
ACTION
logo facing the
mounting brackets to the top profiles requires spacers. If you plan on connecting
ACTION
STEP 1
END RESULT
STEP 2
") from the van floor, and the
/
7
8
END RESULT