Installation And Connection - AKG DAM Série Mode D'emploi

1. Use the supplied PS 3 F-Lock panel mount socket to
install the Installation Module in a tabletop or an op-
tional SA 60 stand adapter to mount the Installation
Module on a floor or table stand.
• For even better vibrational noise rejection, you can fix
the Installation Module to the tabletop with an op-
tional H 500 (see fig. 14) or H 600 + A 608 shock
mount (see figs. 15 and 16).
2. Use a shielded cable to connect the Installation Mod-
ule to a microphone input with phantom power.
3. If the phantom power on your mixing console is
switchable, switch the phantom power on. (Refer to
the instruction manual for your mixing console.)
The Capsule Module and the LED ring will be pow-
ered from the phantom supply.
DISCREET ACOUSTICS modular

4 Installation and Connection

4.2.2 Installation
and Connection
Note:
31