Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Fault
Possible causes
The
The refrigerator is not
refrigerator
connected to the mains.
does not work.
The circuit breakers or fuses are
damaged.
There is no electricity or there
has been a power cut.
Abnormal
The refrigerator is not stable.
noise.
The refrigerator is in contact
with the wall.
Low cooling
The food introduced is hot or
efficiency.
there is too much food.
You open the door too often.
The door gasket has objects
that do not allow to close it
completely.
The refrigerator receives direct
sunlight or is close to a heat
source.
The refrigerator is not well
ventilated.
The selected temperature is
too high.
Unpleasant
There is spoiled food inside.
smells in the
The refrigerator is dirty.
refrigerator.
You introduced food with strong
smells.
The buttons do
Check if the child lock is active.
not work.
You cannot
Check if the Smart or fast freeze
set the
functions are not active on the
temperature.
control panel.
74
Possible solutions
Plug the refrigerator into the mains.
Open the door and check the light
is on.
Set the adjustable feet of the
refrigerator.
Separate the refrigerator from the
wall.
Introduce food in the refrigerator
when it is at room temperature.
Check and close the door.
Remove the refrigerator from the
heat source.
Keep the recommended distances
in the installation section so the
refrigerator is well ventilated.
Set a suitable temperature.
Dispose of food which is spoiled.
Clean the refrigerator.
Pack food, especially if it has a
strong smell.
Hold down the Unlock button for 3
seconds to deactivate the child lock
and press any button (to get more
information, read the instructions
on the child lock).
Deactivate the special functions
and then set the temperature (for
more details, check the Functions
section).
The
Check that the power supply
temperature
has not been cut off before.
on the freezer
compartment
is shown on
the panel, but
it flashes.
Please note
If none of these situations match your problem, do not attempt to disassemble or repair the
refrigerator yourself. Repairs carried out by unqualified persons may result in injury or serious
malfunctions. Please contact the place where you bought the appliance or the official Cecotec
Technical Support Service. The repair must be carried out by an authorised technician, and you
must use only original spare parts.
Error code
E0 (while the freezer-compartment icon
is lit up)
E0 (while the refrigerator-compartment
icon is lit up)
E1
EC
EH
I
f faults E0 and E1 should light up simultaneously, E2 will light up instead.
-
In case the sensor or compartment faults are more than two, the number will be shown.
-
If any of these codes is shown, contact the Technical Support Service of Cecotec.
8. TECHNICAL SPECIFICATIONS
You can find more information on this model by scanning the QR code on the energy label.
BOLERO COOLMARKET SBS 559 INOX / DARK / GLASS D (X/M/S/T)
ENGLISH
Press any button to activate the
alarm (check the overheating
warning section) and check that the
food inside the refrigerator is not
spoiled.
Error type
Fault of the freezer compartment sensor
Fault of the refrigerator compartment sensor
Fault of the refrigerator evaporator sensor
Fault in the communication
Fault of the room temperature sensor
75
Publicité
