Num'axes PIE1028 Guide D'utilisation page 39

SURVEILLANCE
(oldest pic.
overwrite)
PIE1028 – indice A – avril 2018
Press the LEFT button to select ON then the
RIGHT button to set up the Delay (PIR interval).
00:00:00 (HH:MM:SS)
Press the LEFT button to choose the desired digit
then the RIGHT button to confirm and move to
the next digit.
Once the Delay (PIR interval) is programmed,
press the RIGHT button again to exit.
_______________________________
In ON mode, this parameter indicates how long
the PIR sensor will be disabled after each
triggering. During this time the PIR sensor will not
react to the motion of humans or animals. This
parameter prevents camera taking to many
photos or videos.
Example: if Delay (PIR interval) is set on 00:01:00,
the camera will wait 1 minute between
photo/video recordings with motion.
Note: please don't turn "ON" TIME LAPSE and
DELAY simultaneously.
Press the RIGHT button to enter.
1. OFF (default setting)
2. ON
Press the LEFT button to navigate then the RIGHT
button to save the setting and exit.
_______________________________
Select "ON" to activate cycle recording. When the
micro SD card will be full, the camera will
continue to record photos/videos by deleting
earliest photos or video clips.
39/120