Franke ZA3OP0034 Notice De Montage Et De Mise En Service page 6

Zone switchover
9.4 Move the zone switchover (3).
• This switches between set A and set B for e.g.: Daylight saving time and standard
time, day/night mode or room occupied/unoccupied.
• The function depends on the content of the program ID in the electronics
modules.
Thermal disinfection start command
9.5 Move and hold the key (4).
☞
The contact must be closed for at least 5 s and no more than 2 minutes.
LED for thermal disinfection (5)
If thermal disinfection is running, this LED lights up.
☞
Normal function: Permanent ON for the duration of the thermal disinfection.
LED for collective error (6)
If there is a general error, this LED lights up.
☞
Function for fitting or function collective error: Permanent ON.
- 6 -