Publicité
Les langues disponibles
Les langues disponibles
FUNCTIONAL DESCRIPTION
1
11
9
10
1. Trigger
2. Handle
3. Power/Actuation
selection
4. Belt hook
5. Rafter hook
6. Nail slot
7. Magazine
8. Nail pusher
9. Pusher release button
10. Workpiece contact bracket
11. Jam latch
12. LED
SYMBOLOGY
Volts
Direct Current
Single Sequential Actuation
Contact (Bump) Actuation
Wear Eye Protection
Keep Hands Away
Read Operator's Manual
UL Listing for Canada and U.S.
3
4
2
7
8
12
WARNING
cific charging instructions, read the operator's
manual supplied with your charger and battery.
5
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
WARNING
6
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
WARNING
may be hazardous.
Installing/Removing Fastener Strips
WARNING
Always wear safety goggles or glasses with side
shields.
Keep fingers clear of fastener track of magazine.
Pusher could pinch fingers, causing injury.
To install fastener strips:
1. WARNING! Remove battery to avoid starting the tool.
Always point the tool away from yourself and
others when installing fasteners. Failure to do so
could result in injury.
2. Add more fasteners by sliding a strip into the nail
slot and down toward the front of the tool. Be
sure the point of the fasteners is pointed down-
ward. Do not exceed the magazine's capacity.
WARNING! Use only recommended fasteners of
the correct size, length, collation angle and head
type as indicated on the tool's nameplate. Other
fasteners could result in tool malfunction, leading
to injury.
3. Press and hold the pusher release button and slide
the pusher back past the end of the fastener strips.
4. Continue to hold the pusher, but release the but-
ton. Slowly slide the pusher forward until it rests
against the fastener strip.
To remove fastener strips:
1. WARNING! Remove battery to avoid starting the tool.
Always point the tool away from yourself and
others when installing fasteners. Failure to do so
could result in injury.
2. Press and hold the pusher release button and slide
the pusher towards the front of the tool. Release
the pusher.
3. Slide the nails back and out of the nail slot.
4
ASSEMBLY
Recharge only with the charger
specified for the battery. For spe-
Always remove the battery pack
any time the tool is not in use.
Only use accessories specifically
recommended for this tool. Others
Always remove battery pack before
changing or removing fasteners.
Publicité
