Portamate PM-4000 Manuel De L'utilisateur page 4

8. Disconnect tools from service.
9. Use correct tools for the job.
10. Never force a tool.
11. Wear safety apparel.
12. Wear safety glasses/goggles.
13. Never stand or sit on tools.
Safety Instructions for
Miter Saw Stands
1. Use caution when folding or unfolding legs to limit any finger pinch points.
2. Place stand on flat and level surface to keep tool from rocking or tipping.
3. Make certain that work support extensions are within safe operating limits, and are properly locked in place before
using tool. Do not exceed 500 lbs. on main frame table.
4. Test the setup for stability before proceeding with work.
5. Be sure the miter saw is tightened securely at all mountings before use or folding the stand for transport.
Figure 2
Figure 3
14. Replace damaged components immediately.
15. Make sure your work platform is sufficiently sturdy to
16. Properly anchor power tools to work stands.
17. Use correct blade for job being done.
18. Think Safety. Safety is a combination of operator
Assembly Instructions
Read all assembly instructions completely before attempting assembly.
See parts list on Page 3 for names and Figure 1. Some components may be
factory pre-assembled.
1. Identify all components and hardware. Position the main unit upside-down on
the floor. Extend the legs until the snap pins lock into position.
2. Carefully stand the assembly upright on the floor.
3. Thread 3-point knobs R into the weld nuts on the top of the frame tube. Install
the outrigger support  and secure in place with 3-point knob. Figure 2.
4. Thread 3-point knobs R into the outrigger ends. Install support T's as shown.
5. Locate the machine mounts . Carefully review Figure 3. Note the location
of the spring mounted handles; these should be positioned to the rear of the
saw as shown. This allows for easier installation and removal of the saw.
4
do the specific job at hand.
awareness, common sense and alertness at all times.