INIM PREVIDIA ULTRA216 Manuel D'instructions page 7

Manuale istruzioni - Instructions manual - Manuel d'instructions - Manual de instrucciones - Manual de instruções - Handleiding met instructies
Regulation (EU) No 305/2011
(EU) No. 305/2011.
Directive 2014/53/EU
requirements and other relevant provisions of Directive 2014/53/EU. This product may be used in all EU Countries.
Documents for the users
products may be downloaded free of charge from the web address www.inim.it, getting access to Extended Access and then selecting "Certifications" or requested
to the e-mail address info@inim.it or requested by ordinary mail to the address shown in this manual.
Manuals may be downloaded free of charge from the web address www.inim.it, getting access to Extended Access and then selecting "Manuals".
INIM Electronics s.r.l.
Via Dei Lavoratori 10 - Fraz. Centobuchi
63076 Monteprandone (AP) - Italy
0051-CPR-2826
EN 54-2:1997 + A1:2006
EN 54-4:1997 + A1:2002 + A2:2006
EN 54-21:2006
EN 12094-1:2003
PREVIDIA-ULTRA216
PREVIDIA-ULTRA216R
PREVIDIA-ULTRA216D
Control and signalling panel with power-supply equipment, alarm transmission and fault
signalling equipment, automatic electrical device for control and management of switch off
and delay for fire detection and signalling in buildings and for gas extinguishing systems
installed in buildings as part of a complete operating system.
Essential features
Performance in the event of fire
Power supply performance
Response delay (response time in the event of fire)
Transmission performance
Operating reliability
Thermal resistance
Vibration resistance
Durability of
operating reliability:
Humidity resistance
Electrical stability
This symbol indicates to installer to refer to the instructions manual.
Warranty
Inim Electronics S.r.l.. (Seller, Our, Us) warrants the original purchaser that this product shall be free from defects in materials and
workmanship under normal use for a period of 24 months.
As Inim Electronics does not install this product directly, and due to the possibility that it may be used with other equipment not approved by Us;Inim Electronics
does not warrant against loss of quality, degradation of performance of this product or actual damage that results from the use of products, parts or other
replaceable items (such as consumables) that are neither made nor recommended by Inim Electronics. Seller obligation and liability under this warranty is expressly
limited to repairing or replacing, at Seller's option, any product not meeting the specifications. In no event shall Inim Electronics be liable to the purchaser or any
other person for any loss or damage whether direct of indirect or consequential or incidental, including without limitation, any damages for lost profits, stolen
goods, or claims by any other party caused by defective products or otherwise arising from the incorrect or otherwise improper installation or use of this product.
This warranty applies only to defects in parts and workmanship relating to normal use. It does not cover damage arising from improper maintenance or negligence,
damage caused by fire, flood, wind or lightning, vandalism, fair wear and tear.
Inim Electronics S.r.l. shall, at its option, repair or replace any defective products. Improper use, that is, use for purposes other than those mentioned in this manual
will void the warranty. Contact Our authorized dealer, or visit our website for further information regarding this warranty.
Limited warranty
Inim Electronics S.r.l. shall not be liable to the purchaser or any other person for damage arising from improper storage, handling
or use of this product.
Installation of this Product must be carried out by qualified persons appointed by Inim Electronics. Installation of this Product must be carried out in accordance
with Our instructions in the product manual.
Copyright
The information contained in this document is the sole property of Inim Electronics S.r.l.. Copying, reprinting or modification of this
document, in part or as a whole, is not permitted without prior authorization in writing from Inim Electronics S.r.l.. All rights reserved.
WEEE
Informative notice regarding the disposal of electrical and electronic equipment (applicable in countries with differentiated waste collection
systems)
The crossed-out bin symbol on the equipment or on its packaging indicates that the product must be disposed of correctly at the end of its working life
and should never be disposed of together with general household waste. The user, therefore, must take the equipment that has reached the end of its
working life to the appropriate civic amenities site designated to the differentiated collection of electrical and electronic waste. As an alternative to the
autonomous-management of electrical and electronic waste, you can hand over the equipment you wish to dispose of to a dealer when purchasing
new equipment of the same type. You are also entitled to convey for disposal small electronic-waste products with dimensions of less than 25cm to the
premises of electronic retail outlets with sales areas of at least 400m2, free of charge and without any obligation to buy.
Appropriate differentiated waste collection for the subsequent recycling of the discarded equipment, its treatment and its environmentally compatible
disposal helps to avoid possible negative effects on the environment and on health and favours the re-use and/or recycling of the materials it is made of.
Information about disposal of batteries and accumulators (applicable in Countries with separate collection systems)
This marking on batteries and/or their manual and/or their packaging, indicates that batteries of this products, at the end of their working life, should not be
disposed of as unsorted municipal waste, but must be object of a separate collection. Where marked, the chemical symbols Hg, Cd o Pb indicate that the
battery contains mercury, cadmium or lead above the reference levels of the directive 2006/66/EC. If batteries are not properly disposed of, these
substances, together with other ones contained, can cause harm to human health and to the environment. To protect human health and the environment, to
facilitate treatment and recycling of materials, separate batteries from other kind of waste and use the collection scheme stated in your area, in accordance to
current laws. Before disposing of the above, it's appropriate to remove them from their holders avoiding to damage them or causing short circuits.
This product complies with requirements stated by standards listed here below in compliance with Regulation
Hereby, INIM Electronics S.r.l. declares that the Previdia Ultra control panels are in compliance with the essential
Declarations of Performance, Declarations of Conformity and Certificates concerning to INIM Electronics S.r.l.
0051
22
Performance
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
Options provided in accordance with EN54-2
7.8 Output to fire alarm devices
7.9 Output to fire alarm routing equipment
7.10 Output to fire protection equipment
7.11 Delay on outputs
7.12 Co-incidence detection (Type A, B and C)
7.13 Alarm counter
8.3 Point fault signal
8.9 Output to remote fault or warning signalling devices
9.5 Addressable points out-of-service
10.0 Test condition
Options provided in accordance with EN12094-1
4.17 Delay of extinguishing signal
4.18 Signal representing the flow of extinguishing agent
4.19 Monitoring of the status of components
4.20 Emergency hold device
4.21 Control of flooding time
4.22 Initiation of secondary flooding
4.24 Triggering signals to equipment within the system
4.26 Triggering of equipment outside the system
4.27 Emergency abort device
4.28 Control of extended discharge
4.29 Release of the extinguishing media for selected flooding zones
Additional information according to EN 54-2
About information required at point 12.2.1, see data contained in this manual.
Additional information according to EN 54-4
For the information required by point 7.1, see data contained in this manual.
Additional information according to EN 54-21
For the information required by point 7.2.1, see data contained in this manual.
Additional information according to EN 12094-1
Environmental class: A
Degree of protection: IP30
Flooding zones: up to 24
Zones from 1 a 24 for CO2, inert gas or halogenated hydrocarbons.
Response delay activation condition: max 3s
Response delay triggering of outputs: max 1s
Performance
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
Performance
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
PASS
7