How To Use The Core Bit (For Light Load) - Hitachi DH 24PM Mode D'emploi Et Instructions De Securite

(2) Press the push button and set the change
lever to middle of
(Fig. 14)
The rotation is released, turn the grip and
adjust the cold chisel to desired position.
(Fig. 15)
Push
button
Fig. 14
Grip
Fig. 15
(3) Turn the change lever to
(Fig. 13)
Then bull point or cold chisel is locked.
7. Using depth gauge (Fig. 16)
(1) Loosen the knob on the side handle, and
insert the depth gauge into the mounting
hole on the side handle.
(2) Adjust the depth gauge position
according to the depth of the hole and
tighten the knob bolt securely.
Mounting hole Depth gauge
Knob on side
handle
8. How to use the drill bit (taper shank)
and the taper shank adaptor.
mark and mark.
Change lever
mark.
Fig. 16
(1) Mount the taper shank adaptor to the
rotary hammer. (Fig. 17)
(2) Mount the drill bit (taper shank) to the
taper shank adaptor. (Fig. 17)
(3) Turn the switch ON, and drill a hole in
prescribed depth.
Drill bit
Taper shank
auaptor
Fig. 17
(4) To remove the drill bit (taper shank),
insert the cotter into the slot of the taper
shank adaptor and strike the head of the
cotter with a hammer supporting on the
rests. (Fig. 18)
Taper shank adaptor
Cotter
Rests
Fig. 18

HOW TO USE THE CORE BIT (FOR LIGHT LOAD)

When boring penetrating large hole use the
core bit (for light load). At that time use with
the center pin and the core bit shank
provided as optional accessories.
1. Mounting
CAUTION:
Be sure to turn power OFF and
disconnect the plug from the receptacle.
(1) Mount the core bit to the core bit shank.
(Fig. 19)
English
Grip
Front cap
13