Starting The Geolocation System - Num'axes Canicom GPS Guide D'utilisation

To switch your collar off, press and hold the on/off button again
a long time) and the two LEDs on the front light up at the same time, then go off. Your collar is off.
▪ Switching the handheld on/off
Tip: Do not switch your handheld on inside a building or home. Go outside and choose a clear area. Do
not stand under any trees or dense foliage or in a place where satellite signals could be blocked by
large obstacles (blocks of flats, ravines, etc.).
To switch your handheld on, simply press and hold the on/off button
screen lights up and you see the NUM'AXES logo appear. The handheld vibrates 3 times in rapid
succession: it is now working.
To switch your handheld off, repeat the same operation and hold down the on/off button
handheld's screen turns off. It vibrates once (for quite a long time): your handheld is off.

Starting the geolocation system

✓ Step No. 1: Calibrate the electronic compass (if the handheld asks you)
Turn your handheld on: a message is displayed: the compass has to be calibrated.
Press the
" calibrate"
Press the key (in the top left) to calibrate your handheld.
Follow the instructions displayed on the screen:
Guide Canicom GPS – Indice B
key
: the collar vibrates once (for quite
❺
on the handheld until the
until the
24/84