BorMann PRO BTC5500 Mode D'emploi page 3

EN
Blade Adjustments
Honing the Blade:
Push the handle down until the blade is open 6mm/
the small burr that forms when cutting hard products.
Blade Sharpening & Blade Replacement:
The blade can be sharpened several times before a replacement blade is necessary. Replace with the appropriate blade (contact after sales Service).
Cut Guide
CAUTION! USE HAND PROTECTION!
The tool cuts a wide variety of products. Please refer to this cut guide for recommended products and thicknesses:
Laminate Flooring
(Residential Grade ACL AC2 and AC3 only-
Not Intended for Commercial Grade Laminates)
Engineered Wood
Parquet
PVC Tile
Vinyl Composite Tile
Rubber Tile
Carpet Tile
Soft Plastic
Leather
Cork
Wood Siding
Fiber Cement
Blade Adjustment Instructions
1. Unscrew and remove
the adjustment plate screws.
Cuts
Caution! Make sure you wear hand and eye protection during operation.
1. While gently pushing the handle down, slide the safety catch inwards and then lift the handle. Important: Hold the material firmly in place to ensure a clean
precision cut.
2. Place the material to be cut on the table. Bring the handle down until the blade touches the material. Warning! The blade is very sharp. Keep fingers away
from the blade.
3. Press the handle completely down to cut the material.
4. The safety lock must be placed in the locked position after you have completed the work.
Warning! Disabling the reset function on the safety lock is potentially dangerous.
3
. Place a flat surface of the grinding stone on the blade and slide edge to edge 2 to 3 times. This removes
1/4"
15mm or 9/16"
10mm or 3/8"
12mm or 1/2"
12mm or 1/2"
12mm or 1/2"
15mm or 9/16"
12mm or 1/2"
12mm or 1/2"
15mm or 9/16"
15mm or 9/16"
15mm or 9/16"
15mm or 9/16"
2. Tighten both adjustment plates
by 1 or 2 holes.
Note! The pitch on each lifting screw
is 0,125 mm. The adjustment on both
plates must be the same.
Important! After every 500 cuts, it is recommended to lubricate the driving sleeve with 10W-30 engine oil from above after
removing the black caps. This will prevent premature wear of the machine.
WWW.NIKOLAOUTOOLS.COM
3. Cut a piece of paper to ensure
that the tool is set up correctly.