Publicité
Les langues disponibles
Les langues disponibles
UDR300
DESCRIPTION TRANSMITTERS
HANDHDELD :
1)
LCD display
Show you frequency, batteries level, sensibility,....
2)
On/Off switch
Use to switch the handheld mic on or off
3)
IR sensor
This sensor is used to operate the IR frequency sync with transmitters. Don't cover this sensor
4)
Low batteri indicator ( LCD )
When this indicator is display, that means the level of batteries is too low. You must to change it
5)
RF level ( LCD )
These two indicators ( H and L ) give you a visual information about RF signal level ( H for high and L for Low )
BELT TRANSMITTER :
6)
Antenna
7)
On/Off switch
Use to switch the belt transmitter on or off. To switch the belt transmitter on, press and hold the button during 2-3 seconds. Same way
to switch the device off
8)
Mic socket
Connect on this socket a tie mic or an headset mic
9)
Batterie place
To replace batteries ( 2x batteries 1.5V ) :
-
Open the cover
-
Put off the two old batteries
-
Insert the two new batteries ( Respect the polarity )
-
Close the batteries cover
© Copyright LOTRONIC 2015 UDR300
WWW.BSTDJ.COM
Page 9
Publicité
