Publicité
Les langues disponibles
Les langues disponibles
UDR300
DESCRIPTION RECEIVER
Front panel :
1)
On/Off switch
To switch the receiver on or off.
2)
Channel A level control
This control is used to adjust level of channel A output signal
3)
Channel A menu buttons
These three buttons are used to select different menu for the channel A receiver ( frequency group, frequency, IR sync.... )
4)
LCD display
One LCD display by channel. Shows frequency, AF and RF level, group of frequency,....
5)
Channel B level control
This control is used to adjust level of channel B output signal
6)
Channel B menu buttons
These three buttons are used to select different menu for the channel B receiver ( frequency group, frequency, IR sync.... )
7)
IR sensor
This sensor is used to operate the IR frequency sync with transmitters. Don't cover this sensor
Rear panel :
8)
Power connector
Plug on this socket the power adapter delivered with the set ( 12-18V / 500-600mA AC/DC ).
9)
Antenna
10) Channel B output
This balance output is the sound output for channel B. connect it to mic input of the mixer
11) Mixed output
This unbalanced output is the mix of the two ouput ( channel A and channel B ). connect it to mic input of the mixer
12) Channel A output
This balance output is the sound output for channel B. connect it to mic input of the mixer
13) Antenna
© Copyright LOTRONIC 2015 UDR300
WWW.BSTDJ.COM
Page 8
Publicité
