Gardena PowerMax 32/18V P4A Mode D'emploi page 15

4.2 To clean the battery and the battery charger:
The surface and the contacts of the battery and the battery charger must
be clean and dry before the battery is connected to the battery charger.
v Do not use running water.
4.2.1 To clean the battery:
v Occasionally clean the ventilation slots and the terminals on the battery
using a soft brush that is clean and dry.
4.2.2 To clean the battery charger:
v Clean the contacts and the plastic parts with a soft and dry cloth.
5. STORAGE
5.1 To put into storage:
The product must be stored away from children.
(19) to position 0 and remove it to prevent the battery
1. Turn the safety key
from discharging.
2. Remove the battery.
3. Charge the battery.
4. Empty the grass catcher box
5. Clean the mower, the battery and the battery charger
(see 4. MAINTENANCE).
6. Store the mower, the battery and the battery charger in a dry, enclosed
and frost-free place.
5.1.1 Storage position to save space [ Fig. S1 ]:
(7)
1. Loosen both wing nuts
2. Fold the upper handlebar
Make sure that the cable is not trapped between the upper and lower
handlebar, otherwise the cable may be damaged.
6. TROUBLESHOOTING
DANGER!
Cutting injury due to the blade!
Risk of cut injury due to accidental starting.
v Use gloves.
v Wait for the blade to stop.
v Remove the safety key.
v Remove the batterie.
6.1 To replace the blade [ Fig. T1 / T2 ]:
DANGER!
Risk of physical injury!
Risk of cutting injuries if a damaged or bent knife or one with
unbalanced or chipped cutting edges rotates.
v Do not use the mower when the blade is damaged, bent, out of
balance or has chipped edges.
v Do not regrind the blade.
The GARDENA spare parts are available from your GARDENA dealer
or from the GARDENA service.
v Only use an original GARDENA Replacement blade
For safety reasons, we recommend that the blade be replaced by
GARDENA Service or by an authorised GARDENA dealer.
1. Insert a screwdriver into one of the provided holes
the housing.
The screwdriver thus serves as a stop for the blade.
2. Unscrew the blade bolt (29)
Make sure that the spacer
(29)
3. Remove the blade bolt
14632-20.960.02.indd 15 14632-20.960.02.indd 15
(23)
.
.
(4)
downwards onto the mower.
(28)
at the bottom of
.
ö is not damaged when applying the force.
ä
and the washer .
4. Remove the blade
5. Put the new blade
(this side to grass) must be visible.
ä
6. Put the washer
7. Screw the new blade
15 – 20 Nm). Do not over-torque.
Make sure that the spacer
8. Pull the screwdriver out of the mower.
Make sure that the screwdriver is removed before restarting the mower
again.
6.2 Troubleshooting table:
Problem
Engine is blocked
Loud noises, the mower
is rattling
Mower runs unevenly or
vibrates strongly
Lawn is not cleanly mowed
Mower does not start or
stops.
(L1)
LED blinks green
[ Fig. O4 ]
Mower does not start or
stops.
(Wp)
Error-LED lights red
[ Fig. O4 ]
Mower does not start or
stops.
Error-LED (Wp) blinks red
[ Fig. O4 ]
Mower does not start or
stops.
Error-LED (Wp) does not
light [ Fig. O4 ]
Charging is not possible.
Battery charge indicator (Lc)
lights continuously green
[ Fig. O3 ]
Charging is not possible.
(Lc)
Battery charge indicator
does not light
Art. 4121
[ Fig. O3 ]
NOTE:
Repairs must only be done by the GARDENA service departments or
specialist dealers approved by GARDENA.
v For any other malfunctions please contact the GARDENA service
department.
ß .
32 32
ß on the mower. The inscription on the knife
32 32
(29)
and the blade bolt on the mower.
ß tight with the blade bolt (29) (tightening torque is
32 32
ö is not damaged when applying the force.
Possible Cause Remedy
Obstacle blocks the motor. v Remove the obstacle.
Cutting height is too low. v Increase the cutting height.
Screws on motor, its fixing v Let the screws be tightened
or on the mower chasing are by an authorised specialist
loose. dealer or the GARDENA
Service.
Blade is damaged or worn. v Replace the blade.
Blade bolt is released. v Tighten the blade bolt.
Blade is very dirty. v Clean the mower. If this does
not solve the problem, con-
tact the GARDENA Service.
Blade is blunt or damaged. v Replace the blade.
Cutting height is too low. v Increase the cutting height.
Battery is empty. v Charge the battery.
Battery temperature is outside v Wait until the battery
the permissible temperature temperature is between
range. 0 °C – + 45 °C again.
There are drops of water or v Remove the water drops or
moisture between the battery moisture with a dry cloth.
contacts.
Obstacle blocks the motor. v Remove the obstacle.
Mower is defective v Contact the GARDENA
Service.
Battery is not put completely v Put the battery completely
into the battery holder. into the battery holder until
it audibly engages.
Safety key is not turned to v Turn the safety key to
positon 1. position 1.
Battery is defective. v Replace the battery.
Mower is defective. v Contact the GARDENA
Service.
Battery is not slid onto the v Slide the battery onto the
charger correctly. charger correctly.
Battery contacts are dirty. v Clean the battery contacts
(e. g. by connecting and dis-
connecting the battery several
times. Replace the battery if
necessary.
Battery temperature is outside v Wait until the battery
the permissible temperature temperature is between
range. 0 °C – + 45 °C again.
Battery is defective. v Replace the battery.
Mains plug of the charger is v Insert the mains plug com-
not plugged in correctly. pletely into the mains socket.
Mains socket, mains cable or v Check the mains voltage.
charger is defective. Let the charger be checked
if necessary by an authorised
specialist dealer or the
GARDENA Service.
15
25.07.22 10:57 25.07.22 10:57