Rise SPARTACUS 200/600 Manuel D'installation page 11

ATTENTION: Carefully read the instructions manual in all of its pars and keep it in a safe location for any future consultation. Not following the stan-
dards and warnings included in the present manual or an incorrect installation may damage persons or property.
- This product has been designed and manufactured exclusively for the use indicated in this documentation. Any non-conforming use may damage the
product or be a source of danger for persons and/or property.
- Do not install the product in an explosive atmosphere: the presence of flammable gasses or vapours is a source a serious danger.
- Installation must be completed in observance of current standards.
- For installation in countries outside of the EEC, besides national reference regulations, the above mentioned standards and warnings must be obeyed
in order to obtain a suitable level of safety.
- Verify that the system has been earthed according to Good Practice standards and the metal parts must be connected to it.
- For each system, a suitable sign is recommended.
- Do not stand in the movement area of the bollard.
- Do not leave packaging materials (plastic, polystyrene, wood ...) within reach of children because they may be a potential source of danger.
- Do not allow children to play with the commands or in proximity of the bollard.
- In the case of functioning anomalies do not attempt to repair the fault but contact a specialised technician. Only use original RISE Srl accessories.
- Do not modify any components that are part of the RISE system. Any modification, alterations or tampering with the RISE system, or the use of non
original RISE accessories, will cause the product warranty to lapse and RISE Srl declines any responsibility with regards to safety and proper system
operation.
- The installer must provide the user with all information necessary for system use and maintenance along with manual and emergency manoeuvres. He
must deliver them and the user must request the booklet containing warnings and use and maintenance standards.
- The bollard must be completely lowered before transiting through the controlled passage area.
- Anything that is not specifically planned for in these instructions is not allowed.
In case of flooding or significant precipitation that causes obvious drainage problems, avoid using the bollard until normal conditions have been restored.
Maintenance to bollards, control units and the entire system must be completed exclusively by specialised technical personnel.
The RISE bollards do not require any special maintenance, periodically checking that the area around the bollard is sufficiently clean and, as needed,
the gaskets at the base of the bollard should be replaced. Programmed routine controls of the entire system are recommended only in cases of intense
product use in order to ensure correct operation and long product life.
If the bollard is withdrawn from service, the current laws and regulations in force concerning the separate waste disposal and the recycling of the various com-
ponents (metals, plastics, electric cables etc.) must be respected; it is advisable to contact your installer or a specialised company, authorised for the purpose.
TECHNICAL DATA
Cylinder height
Cylinder diameter
Cylinder thickness
Cylinder material
Ascent time
Descent speed
Supply
Power consumption
Hydraulics
Load class according to EN 124
Manual lowering in case of blackout
Automatic lowering in case of blackout
Obstacle detection in ascent
Capacitor
Daily cycles
Total cycles
Resistance to breakthrough
Impact resistance
Operating temperature
Degree of protection
Weight (without foundation box)
WARNING
SAFETY STANDARDS
ATTENTION: PRECAUTIONS FOR USE
DISPOSAL
200/600 200/800
600
S355JR Steel S355JR Steel
3 seconds 4 seconds
3 seconds 4 seconds
230V 50Hz (versions with special power supply on request)
for temperatures below -10°C (the optional heater accessory must be used)
70 kg
MODELS
200/600 - I
800 600
200mm
6mm
AISI 316 Stainless Steel
3 seconds
3 seconds
550W
integrated
D250 (25 tonnellate)
Manual release
Optional
Optional
25 μF
3500
3000000
35.000 J
150.000 J
-40°C ÷ +60°C
IP67
78 kg 74 kg
200/800 - I
800
AISI 316 Stainless Steel
4 seconds
4 seconds
83 kg
SPARTACUS 11