FAURE FFV919Y Notice D'utilisation page 21

It is recommended to leave the hood
operating for approximately 15 minutes
after cooking.
The control Panel is a sensor field.
Touch the symbols for 1 second to
activate the functions.
To operate the hood:
1. Turn on the appliance by pressing the
symbol.
You can now activate the functions.
2. To activate the function touch the symbol.
3. If needed, touch the light symbol
illuminate the cooking surface.
To turn off the appliance press the
again.
HOB TO HOOD FUNCTION
It is an automatic function which connects the hob
with a hood. Both the hob and the hood have an
CARE AND CLEANING
CLEANING THE GREASE FILTER
Each filter must be cleaned at least once a month.
Filters are mounted with the use of clips and pins
on the opposite side.
To clean the filter:
1. Pull the cover to open it.
2. Press the handle of the mounting clip on the
filter panel underneath the hood (1).
While boiling and frying big quantities of food without a lid,
big humidity.
Refreshes the air in kitchen after cooking at a very low noise
level. It can be activated and de-activated by touching the
symbol. The function turns off automatically after 60 mi-
nutes. Use after cooking only.
to
symbol
1
infrared signal communicator. Speed of the fan is
defined automatically on basis of mode setting and
temperature of the hottest cookware on the hob.
You can also operate the fan using the hob
manually. The function can be activated from panel
of the hob.
For more information how to use the
function refer to the hob user manual.
ACTIVATING MAXIMUM MOTOR SPEED
When you press the button
Motor Speed starts to operate for 8 minutes. After
that time, the appliance returns to its previous
speed settings.
When the function is turned on,
additional touch on the button
does not have any effects.
1
2
3. Slightly tilt the front of the filter downwards (2),
then pull.
Repeat the first two steps for all filters.
4. Clean the filters using a sponge with non
abrasive detergents or in a dishwasher.
, the Maximum
21