Beamz professional Proteus 1,5W RGB PRO Laser DMX SD Manuel page 11

file3.ild. The play speed of file1.ild is 12k, repeat playing 3 times. The play speed of file2.ild is 20k,
playing once, and this file is created by ISHOW software. The play speed of file3.Ild is 18k, playing 4
times. Then the content of "prg1.prg" is as follows:
File1.ild,12,3
File2.ild,20,1,i
File3.ild,18,4
When creating a new folder, user should build a .prg file with the same name as this folder. In our
example above "prg1.prg" would be contained within a folder on the SD card called prg1. The user must
list all ILDA files under this folder to the .prg file. The edited playing speed represents the speed in "ILDA
mode". For example, user can create an "aurora.prg" under the folder of "aurora".
When user adds new ILDA file to this folder, he should also edit this ILDA file to the PRG file. In this
way, user will find this ILDA file under "ILDA mode", and can set the play speed.
TROUBLE SHOOTING
1. If the power supply indicator is off and the laser doesn't work, please check the power supply and
the input voltage.
2. In Stand-Alone operation, if the power supply indicator is ON and sound active indicator is OFF, but
the laser doesn't work.
A. Because sound is too small and cannot activate laser running, please increase the music volume
or increase audio sensitivity on rear panel.
B. Please check if unit has been set up in slave mode, or DMX mode.
3. In Master-Slave operation, slave units don't function, please check as below.
A. Make sure there's only one master in the chain, and the others are set in slave mode.
B. Make sure to control the units with DMX controller.
C. Make sure to use a good quality power cable and XLR connector.
4. If the output beam direction above is unusual, please restart the unit.
5. If the unit is fail, please turn off the unit, and then turn on again after 5 minutes.
After trying the above solution you still cannot sort out the problem, please contact your dealer or
our company for service.