Publicité
Les langues disponibles
Les langues disponibles
PRODUCT SPECIFICATIONS
General Specifications
All Models
Fan Speeds
Filters
Total Connect Load
Lights
Model Specific
Model Number
Filters
Weight Specifications
Model Number
SKSPH4802S
SKSPH3602S
Adjusting Maximum CFM
Level
Local codes in some areas limit the maximum CFM of
installed range hoods. You can adjust the maximum
blower CFM of this hood to avoid the need for an
expensive make-up air kit. During install, you can
easily set the maximum blower speed to one of two
commonly specified CFM levels. (See the chart). You
may not need to adjust the CFM of the hood. Check
local codes for CFM restrictions.
Default Max
Model
CFM Level
SKSPH3602S
600
SKSPH4802S
1200
CAUTION
• Disconnect the hood from the main power
supply prior to following the conversion
instructions. Failure to do so could result in
personal injury or damage to the product.
• After re-positioning the jumper and powering on
the hood, the CFM cannot be changed again.
5
Baffle type, dishwasher safe
120 VAC, 60 Hz, 4 Amp.
120 VAC, 8 W LED light strip
SKSPH4802S
4
Weight
71 lb. (32.5 kg)
60 lb. (27.2 kg)
1
2
3
Available
Max CFM Levels
290 or 390
390 or 590
4
PRODuCT SPECiFiCATiONS
SKSPH3602S
3
Before installing the hood, access the PC board
located behind the light panel.
if applicable, remove both spacer panels by
removing the 2 screws in each panel.
Remove the 5 screws securing the light panel.
Change the plastic jumper position on the PC
board to set your desired maximum CFM.
7
Publicité
