FEATURES AT A GLANCE
Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms
against soiled surfaces. First, the dishwasher fi lls with water covering the fi lter area. Water is
then pumped through the spray arms. Soil particles go through and across the fi lter and down the
drain as the water is pumped out. This series of steps are repeated as needed. The number of
water fi lls vary with the cycle being used.
Cup Shelves
(on some
models)
Middle Spray Arm
Lower Spray Arm
Overfi ll Protector
Rinse Aid
Detergent Dispenser
Vent
NOTE
The dishwasher is programmed to remember
your last cycle so you do not have to reset
each time. To start the dishwasher using
the same cycle and options selected on the
previous wash, just press the START/CANCEL
pad.
Recommended Cycle for typical
use:
The Normal cycle along with the heated
dry option together provide the best all
around performance. This cycle selection is
recommended for everyday use and is suitable
for a large range of both dish load size and food
quantities remaining on those dishes.
4
Features may vary according to model
Nozzle or Spray Arm
Wash Cycle Selections
Cycle times are approximate and will vary with
options selected. Hot water is necessary to
activate dishwasher detergent and melt fatty
food soils. An automatic sensor will check
the incoming water temperature and, if it is
not hot enough, the cycle will be lengthend
for automatic water heating in the main wash
and fi nal rinse of all cycles. This happens
even when HI-TEMP WASH option has not be
selected. When HI-TEMP WASH is selected,
an even higher temperature will be reached to
handle heavier soil loads.
If the dishwasher door is opened while the
unit is running, the START/CANCEL pad must
be pressed and the door shut immediately
to return the unit to the selected cycle and
option, this must happen within 10 minutes
for the unit to continue the cycle.
Top Rack
Serial Label
(Located on Right)
Lower Rack
Silverware Basket
NOTE
Glass Trap
Heating Element