Willbe Meiki Power TS70 Manuel D'instructions page 9

METHODS OF STARTING AND STOPPING THE ENGINE
Please read carefully and understand the section of "For safe use" in this
manual before use.
1. Turn on the engine switch to "ON".
(The engine switch may be provided on the working
machine depending on the specifications.)
2. Repeat pressing the priming button with finger till it
hits the top.
Repeat this until the fuel starts to return to the tank
through the transparent pipe.
3. Fully close the choke lever. If the fuel is
reserved and the engine is warm, put the
choke lever at the fully opened position.
4. Turn the throttle lever to the "low speed" position.
5. Holding down on the working machine, grasp the
recoil starter grip and strongly pull it.
Do not step on the engine when starting it.
It could damage the equipment.
Once the engine has started, return the recoil starter
grip slowly to the original position.
6. After the start, move the choke lever gradually to
the fully opened position observing the condition of
engine.
When engine produces explosion sounds but fails
to start, move the choke lever to the fully opened
position and then pull the starter grip strongly again.
Starting the engine
7
Priming
button
Close
Open
Choke lever
Low-speed